MCHITCH
Heritage Softail Harness Installation Instructions

 

Remove the seat.
Undo the plug shown below and install the MCHITCH Wiring Harness Plugs between them. Attach ground wire to a good ground source (bolt) 
Route the wires to the rear of the bike
Be careful to place wires where they will not get pinched or rub on sharp objects.
Attach the plug (not supplied) to the end of the harness that matches the plug on your trailer. (This step is not necessary if using a MCHITCH Isolator / Converter  Harness)
 (It is advised to wrap the wires with electrical tape to help protect them, after determining the correct length and how to route them to the rear of the bike)
Use plastic ties (not included) to secure the wires.
Attach positive wire to 12v source (battery) if using a MCHITCH Isolator or Isolator / Converter Wiring Harness.  Replace the seat.